| Specification | Description |
|---|---|
| Manufacture | Miscellaneous - see below |
| Line Speed | Min. 29 fpm @ 48" x .062" |
| Max. 199 fpm @ 30" x .015" | |
| Strip Thickness | .015" - .062" steel |
| Strip Width | 49" maximum untrimmed |
| Coil Size | ID - 16-20" entry, 20-24" exit |
| Weight - 20,000 lbs. max | |
| Configuration | Single-coat, double side |
| Vertical coater and oven | |
| Runs solvent & water based | |
| Equipment | |
| - Uncoiler 1 | Cincinnati-Forte, 1973 |
| Hold down roll | |
| Sliding base, scissors coilcar | |
| - Uncoiler 2 | Emag, 1973, sliding base |
| Holddown roll, above floor car | |
| - Strip Joiner | Behlen |
| - Entry Shear | Wysong, .075" x 72" capacity |
| - Cleaning Section | Upgraded in 1993 |
| 4-stage, clean only | |
| Wash - rinse - rinse - dry off | |
| - Vertical Roll Coater | by Union Roll Coater Equipment |
| - Vertical Induction Furnace | by LO Swartz, 1993 |
| $100,000+ new spares included | |
| - Incinerator | Haden-Schweitzer, infrared |
| - Exit Crop Shear | Cincinnati |
| - Recoiler | Emag, manual grip and expand |
| Hyd push-off, above floor | |
| L-shaped coil car | |
| - Electrics | 480 V / 3 phase / 60 Hz |
| Sold "as is, where is" installed and running. | |
| A group of components are also available with this line at extra cost. | |
| Please ask for our reference CC-089! |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com