Request A Quote On This Item| Specification | Description |
|---|---|
| Manufactured | Waldron / 1964 |
| Continual upgrades | |
| Strip Thickness | |
| - Rated | .015" max / 0.38mm |
| - Actual Use | .010 - .032" / 0.25 - 0.80mm |
| Strip Width | 46.625" actual max / 1184mm |
| 48" possible w/ 52" roll faces | |
| Line Speed | 450 fpm max / 137mpm |
| Coil Size | ID - 16" / 406mm |
| OD - 80" max / 2032mm | |
| Wt - 20,000lbs max / 9mtons | |
| Products Coated | ALUMINUM can end stock |
| Can tab stock | |
| Food can stock | |
| Building Products | |
| Has coated STEEL | |
| Variety of solvent-based coats | |
| Equipment | |
| - Dual Uncoilers | 2 uncoilers on common rotating |
| base | |
| - Crop Shear | |
| - Strip Joiner | Single-die Behlen unit |
| - Edge Trimmer | 15hp DC drive, scrap winder |
| - Tension Leveler | Entry & Exit 4-roll tension |
| bridle stands | |
| Flex-Roll Section in between | |
| Entry Bridle = 20,40,75,100hp | |
| differential drives | |
| Exit Bridle = 100,75,40,20hp | |
| differential drives | |
| New mid-1980's. | |
| - Entry Accumulator | "8 over 7" roll configuration |
| Approx. 40 ft tall | |
| - Cleaning Section | |
| - Pretreatment | |
| - Coater | 2-side roll coater |
| 3-roll configuration | |
| - Coater Oven | 3 zones plus quench |
| 800 deg F max temp | |
| 80 ft long | |
| Combo floater/catenary design | |
| - Roll Type Waxer | GFG vertcal type - new 1992 |
| - Electrostatic DOS Applicator | by Trion, vertical type |
| - Exit Accumulator | "8 over 7" roll configuration |
| Approx. 40 ft tall | |
| - Crop Shear | |
| - Recoiler | 40 hp, 300/1800 rpm DC drive |
| - VOC Oxidizer | New 1992 |
| 60,000SCFM used for both lines | |
| Straight incineration, no heat | |
| recovery. | |
| Sold "as is, where is" installed. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com