| Specification | Description |
|---|---|
| Manufacturer | Hunter / 1974 |
| Type | Doubling foil finishing mill |
| Line Speed | 3150 fpm max / 960 mpm |
| Web Width | 58" max, 25" min |
| Web Thickness | Max Entry - .004" / 0.1mm |
| Min Exit - .00025" doubled | |
| Coil Size | ID - 20" / 508mm |
| OD - 60" / 1524mm | |
| Weight - 14,500 lbs / 6.3mtons | |
| Equipment | |
| - #1 Doubling Uncoiler | Cone type |
| 40 hp DC drag generator | |
| ___ gear ratio | |
| - #2 Main Uncoiler | 2 x 40hp DC drag generators |
| Core and coil handling equip. | |
| - Entry Bridle Roll | Hydraulic actuated cylinder |
| 3-5" diam x 60" rolls | |
| - Edge Trimmer | 6" diam female knife arbor |
| 2 trim heads, scrap suction, | |
| Scrap chopper - 5hp motor | |
| - Mill | Direct drive gear ratio |
| 400hp, 1200rpm, 230 VDC | |
| - Work Rolls | 6 work rolls included total |
| 9" min/10" max diam x 64" face | |
| 2 sets of chocks | |
| - Backup Rolls | 6 backup rolls included total |
| 23" min/26"max diam x 62" face | |
| 1 set of chocks | |
| - Drive | 400 hp |
| - Roll Coolant & Filtration System | 300gpm Schneider vert. stack |
| 2 spray bars, 31 nozzles each | |
| 25 hp pump motor | |
| - Fire Suppression System | CO2, included |
| - Recoiler | 2 x 40hp DC motors |
| 1 x 5"diam fixed passline roll | |
| 5" x 60" ironing roll | |
| Air cylinder | |
| - Spools | Jib cranes for spool handling |
| Some steel spools included | |
| Sold "as is, where is" installed, complete. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com