Impact Extrusion: Used Complete Slug Stock Production Line - 175mm Width


Used Complete Slug Stock Production Line - 175mm Width

Stock Number: IEX-069


Impact Extrusion: Used Complete Slug Stock Production Line - 175mm Width, Click to view larger photo...      
Click to view larger photo


SpecificationDescription
DescriptionComplete modern facility
 Installed new in 1987
 Melting through slug annealing
 Installed, not in production
 Demonstration can be arranged
Equipment 
- Melting FurnaceNatural gas fired
 Burners and controls good
- In-Line Molten Metal Degassing & FiltrationFoseco degasser
 Ceramic filter box
 Grain refiner rod feeder
- Wheel & Band Continuous Slab Caster1080mm diam copper alloy wheel
 Max cast rate of 3.6 mton/hr -
 Based on 20mm x 162mm slab
 6.8 - 7.2 mpm casting speed
 6 kW DC motor driving wheel
- Wider Casting Wheel PossibilityCaster is set up to receive a
 wider 220mm wheel that would
 increase the cast rate to
 4.8 mton/hr.
- Cooling SystemPumps, cooling tower, filters
 Can supply 65 cubic meters/hr
 of cooling water to caster.
- Combination Hot/Cold 2-Hi Rolling Mill 
- HotIn-line reduction mill in
 tandem with the caster
- ColdOff-line as a cold mill
- Mill Drive80 kW, 800 rpm DC motor
 1.16:1 gearbox
- Rolls280mm diam x 250mm face
- Max Speed30 mpm
- ScrewdownsElectro-mechanical
- Traveling Hydraulic Shear 
- UncoilerFor use when in cold mill mode
- Coilers (2)12 kW DC drive each
- SparesRolls,chocks,bearings included
- Schuler Slug Blanking Presses1 x 100 mtons, 1 x 80 mtons
(200mm max strip width for both)See IEX-085 & IEX-086
 Wide variety of tooling
 Uncoilers, coil feeders, scrap
 shear, etc.
- Slug Annealing FurnaceElectrically heated
 2.2 mton slug capacity
 Using baskets
 Removal and transport may not
 be feasible.
- ConditionWell maintained
 Spares & consumables included
 Ran only 3 days per week.
- AdditionalLine was shut down late 2004
 Line complete&ready to produce
- Cold Mill (2-Hi)All brand new components
 are included in this sale to
 erect a 2nd mill to be the
 cold mill in the line.
 Mill is a duplicate of the hot
 mill mechanically/electrically
Sold "as is, where is" installed, not running. 
Manufacture available for refurbishment, installation and start-up. 


HomeIndexContactView Cart


Impact Extrusion: Used Complete Slug Stock Production Line - 175mm Width
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com



Asset Sales and Marketing Software for Used and Surplus Industrial Machinery and Equipment Dealers
www.MacDB2000.com