| Specification | Description |
|---|---|
| Overview | Wheel & band continuous caster |
| In-line hot mill | |
| In-line cold mill | |
| 8000 MT/yr slug stock - or - | |
| 250mm wide aluminum coil/strip | |
| 1xxx alloys (mainly) | |
| 16mm thickness max (.630") | |
| Equipment | |
| - Melting/Holding Furnaces | 2 melt/hold combination units |
| 18 mtons holding capacity each | |
| - Wheel & Band Caster | 28mm thick x 250mm wide slab |
| (1.10" thick x 9.84" wide) | |
| 6 mpm minimum cast speed | |
| - 2-Hi Hot Mill | |
| - Rolls | 300mm diam x 400mm face |
| (11.8" diam x 15.8" face) | |
| - Drive | 167 HP, 1500 rpm DC motor |
| 70.97:1 gear box | |
| - 2-Hi Cold Mill | |
| - Rolls | 300mm diam x 400mm face |
| (11.8" diam x 15.8" face) | |
| 167 HP, 1500 rpm DC motor | |
| 35.36:1 gear box | |
| - Crop Shear | |
| - Coilers (2)(Dual) | ID - 508mm / 20" |
| OD - 1500mm max / 59" | |
| - Slug Blanking Presses | Four (4) |
| 16mm (.630") blanking capacity | |
| 90 - 450 strokes per minute | |
| 65+ dies available | |
| - 15.7-65.7mm diam tooling | |
| - Solid and pierced | |
| - Flat and domed | |
| - Slug Blasting | 5 units included |
| - Slug Annealing | 3 batch furnaces |
| 2000 kg loads every 5 hours | |
| for each furnace | |
| Sold "as is, where is" installed and under power. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com