| Specification | Description |
|---|---|
| Manufacture | Lewis / 1954 |
| Line Speed | 850 fpm maximum |
| Strip Thickness | Entry - .375" max - see below |
| Exit - .017"(as currently run) | |
| Strip Width | 52" max as is |
| 58" if move entry bridle to | |
| outside of the mill housing | |
| Coil Size | ID - 20" |
| OD - 60" | |
| Weight - 20,000 lbs. | |
| Separating Force/Mill Post Cross-section | 21" x 27" per post x 4 posts |
| Equipment | |
| - Uncoiler | 20" diam. mandrel type, brake |
| - Main Mill | |
| - Entry Edge Guide | Top roll driven |
| 56" btwn guides, 60" roll face | |
| Hydraulic holddown cylinder | |
| - Entry Bridle | 7 roll |
| - Work Rolls | 15.75" diam x 64" face |
| Total- 16 rolls, 2 sets chocks | |
| Timken roller bearings | |
| - Backup Rolls | 36" diam x 64" face |
| Total- 5 rolls, 2 sets chocks | |
| Morgoil bearings | |
| - Drive | 1500hp, 350/820 rpm DC motor |
| 3.8:1 gearbox, 600 volt | |
| - Recoiler | 20" diam x 62" face mandrel |
| 400 hp, 400/1200 rpm DC motor | |
| 6.14:1 gearbox, 600 volt | |
| Belt wrapper | |
| - Coolant System | Schneider plate filter |
| - Gauge Control | Measurex system with controls |
| - Fire Suppresion | CO2 system (shared) |
| 24 bottles per mill | |
| - Roll Bending | No |
| - Edge Guide | Yes |
| - Spares | Schneider filter |
| Measurex gauge system spares | |
| Belt wrapper spares | |
| Many other minor spares | |
| Buyer shall verify all data during inspection. | |
| This mill made the final "warm" reduction pass in a hot | |
| mill line from .375" to .187". It would then reduce the | |
| .187" metal to .017". The mill also commonly reduced | |
| cast coil from .236" to .017". | |
| Sold "as is, where is" installed, USA. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com