Request A Quote On This Item| Specification | Description |
|---|---|
| Manufacture | Bliss |
| Modified by Tippins 1996 | |
| Line Speed | Stand 1 - 104 / 251fpm |
| Stand 2 - 224 / 559 fpm | |
| Mill Type | 2-stand, 2-Hi tandem hot mill |
| Rolling slab continuously | |
| from a continuous slab caster. | |
| Caster not included. | |
| Slab Size | |
| - Incoming Thickness | .984" max / 25.0mm |
| - Outgoing Thickness | .472" min / 12.0mm |
| - Width | 29.5" max / 749mm |
| Coil Size | ID - 24" |
| OD - 72" max. | |
| Weight - 10,000 lbs. max | |
| Separating Force | 1,600,000 lbs max |
| Equipment | |
| - Entry Shear | Cast coil leading edge shear |
| With scrap handling system | |
| - Entry Pinch Roll | Takes coil from caster to mill |
| - Rolls | 26.5" diam x 36" face |
| - Roll Bearings | Roller type |
| - Roll Count | 12 total |
| 8 spares + 2 in each mill | |
| - Mill Drives | One 1250hp DC motor per stand |
| 125/300 rpm | |
| - Stand 1 | Gearbox ratio = 8.76:1 |
| 460,000 ft lbs torque | |
| - Stand 2 | Gearbox ratio = 4.08:1 |
| 214,000 ft lbs torque | |
| - Hydraulic Gap AGC System | 21" diam cylinders @ 3500 psi |
| Top-mounted, double acting | |
| Isotope thickness gauge | |
| - Rotary Crop Shear | 0.5" max thickness capacity |
| Two 100 hp motors driving | |
| - Two Coilers | 24" diam mandrels |
| 27,000 lbs max tension | |
| 275/550 hp drives | |
| Belt wrappers | |
| Coil cars included | |
| - Roll Changer | Hydraulic |
| - Scratch Brushes | 4 total / located on |
| entry & exit side of each mill | |
| - Hydraulics | Complete |
| - Roll Coolant System | Complete |
| - Fume Exhaust System | Complete |
| Sold "as is, where is" dismantled and in dry storage | |
| Only slightly used / in excellent condition |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com