Request A Quote On This Item| Specification | Description |
|---|---|
| Manufacture | United |
| Nominal Capacity | 900,000 UStons/yr |
| Input Slab Size | |
| - Thickness | 6 - 8.5" / 152 - 216mm |
| - Width | 25 - 50" / 635 - 1270mm |
| - Length | 8 - 18 ft / 2.14 - 5.18 m |
| Hot Rolled Coil Size | |
| - Strip Thickness | .060" / 1.42mm |
| - Width | 22 - 49.75" / 559 - 1263mm |
| - Weight | 22,000 lbs max / 10 mton |
| Line Speed | 1965 fpm max / 950 mpm |
| Equipment | |
| - Slab Reheat Furnace | Two, 200 tons/hr |
| - Roughing Mill | 4-Hi single stand reversing |
| Two 5000 hp drives, 40/100 rpm | |
| 700 VDC motors | |
| Vertical edger | |
| - Coil Box | |
| - Flying Crop Shear | |
| - Hot Strip Mill | |
| - Roll Sizes | 25 & 49" x 56" |
| - Drive Stand 1 | 3500hp, 150/300 rpm DC motor |
| 4.26:1 gear ratio | |
| - Drive Stand 2 | 5000hp, 150/300 rpm DC motor |
| 3.17:1 gear ratio | |
| - Drive Stand 3 | 5000hp, 150/300 rpm DC motor |
| 1.90:1 gear ratio | |
| - Drive Stand 4 | 5000hp, 150/300 rpm DC motor |
| Direct drive | |
| - Drive Stand 5 | 3500hp, 135/270 rpm DC motor |
| Direct drive | |
| - Drive Stand 6 | 3500hp, 150/300 rpm, DC motor |
| Direct drive | |
| - Runout Table | 324 ft / 98 m |
| Features | |
| - Hydraulic AGC system on 6 hot strip stands | |
| - Hydraulic work roll bending on 6 hot strip stands | |
| - Two hydraulic loopers between stands 4&5, 5&6 | |
| - Mill automation system | |
| Sold "as is, where is" off foundation. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com