| Specification | Description |
|---|---|
| Manufacturer | Mesta / 1954 |
| Line Speed | 2200 fpm max exit / 670 mpm |
| Incoming Slab | |
| - Thickness | 8 - 10" / 203 - 254mm |
| - Width | 28 - 57" / 771 - 1447mm |
| - Length | 240 - 348" / 6096 - 8839mm |
| - Weight | 56,000 lbs max / 25.4 mtons |
| Outgoing Coil | |
| - Thickness | .065 - .430" / 1.65 - 10.9mm |
| - Width | 28 - 57" / 203 - 254mm |
| - Coil ID | 28" / 771mm |
| - Coil OD | 72" max / 1828mm |
| - Weight | 56,000 lbs max / 25.4 mtons |
| Nominal Annual Capacity | 2,000,000 UStons carbon steel |
| (1,814,000 mtons) | |
| Equipment | |
| - 2-Hi Blooming Mill | 41" diam x 92" face rolls |
| Ryertex bearings | |
| 537 sq inches post size | |
| Drive - 2 x 3000hp, 40/100rpm, | |
| 600 VDC motor | |
| - 2-Hi Roughing Mill | 43" diam x 59.75" face rolls |
| Morgoil bearings | |
| 600 sq inches post size | |
| Drive - 2 x 5000hp, 40/100rpm, | |
| 600 VDC motor | |
| 1100 fpm max speed | |
| - 6-Stand 4-Hi Finishing Train | |
| - Stand 1 | 5000hp, 125/250rpm, 750VDC |
| 212-424 fpm | |
| - Stand 2 | 5000hp, 175/350rpm, 750VDC |
| 388-776 fpm | |
| - Stand 3 | 5000hp, 90/180rpm, 750 VDC |
| 589-1178 fpm | |
| - Stand 4 | 5000hp, 125/250rpm, 750 VDC |
| 818-1636 fpm | |
| - Stand 5 | 5000hp, 150/300rpm, 750 VDC |
| 982-1924 fpm | |
| - Stand 6 | 3500hp, 175/350rpm, 750 VDC |
| 1145-2290 fpm | |
| - Work Rolls | 26" diam x 64" face |
| (660mm x 1625mm) | |
| Roller bearings | |
| - Back-up Rolls | 53.75" diam x 59.75" face |
| (1365mm x 1517mm) | |
| Morgoil bearings | |
| - Load Cells | by Asea on all 6 stands |
| - Descaling System | |
| - Runout Table | 353 ft long, 225 rolls |
| - Two Downcoilers | With pinch rolls |
| Sold "as is, where is" installed, not in operation. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com