| Specification | Description |
|---|---|
| Manufacture | Hunter / 1964 |
| Strip Thickness | Max Entry - .250" / 6.35mm |
| Common Use Entry - .125" | |
| Min Exit - .015" / 0.38mm | |
| Strip Width | 58.5" max entry / 1486mm |
| Line Speed | 2-speed gearbox |
| Low Speed- 880fpm max /268mpm | |
| High Speed- 2500fpm max/762mpm | |
| Coil Size | ID - 20" / 508mm |
| OD - 60" max / 1524mm | |
| Weight - 12,000lbs max / 5.4mt | |
| Equipment | |
| - New Coil Prep Station | New 2007 |
| - Uncoiler | 20" mandrel |
| 2 x 200hp DC drive | |
| - Mill | |
| - Entry Feed Roll | New 2007 |
| - Drive | 1750 hp DC. MG sets but these |
| are PLC control regulated | |
| - Controls | Reliance AutoMax |
| - Work Rolls | 15" diam x 69" face |
| Roller bearings | |
| 6 sets of new rolls plus older | |
| rolls and spares | |
| - Backup Rolls | 31" diam x 61" face |
| - AGC System | Measurex - using prestressed |
| stand with wedges | |
| - Fire Suppression | CO2 system |
| New 2007 | |
| Central low pressure | |
| - Coolant System | DeLaval filter |
| - Edge Trimmer | New 2007 |
| - Recoiler | 20" mandrel |
| 2 x 200hp DC motors | |
| Sold "as is, where is" installed and under power. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com