| Specification | Description |
|---|---|
| Manufacture | Cincinnati |
| Strip Thickness | .015 - .125" / 0.38 - 3.17mm |
| Strip Width | 12 - 60" / 305 - 1524mm |
| Coil Size | ID - 16 to 24" / 406 - 610mm |
| OD - 72" max / 1828mm | |
| Wt - 30,000 lbs max / 13.6 MT | |
| Equipment | |
| - Entry Coil Car | Floor mounted |
| Self-contained hydraulics | |
| - Entry Prep. Equipment | Braner peeler |
| Mechanical edge guide | |
| Entry passline roll | |
| - Uncoiler | Hydraulic expanding mandrel |
| Hold down roll w/ snubber roll | |
| Wichita water cooled-brake | |
| Sliding base | |
| - Slitter Head | 2 interchangeable heads |
| Crane removeable | |
| 75hp 400/1200rpm DC drive | |
| 6.0" diam arbors | |
| Slitter head setup stands | |
| Shimless knives | |
| Rubbers, spacers included | |
| - Recoiler | Hyd. expanding mandrel |
| Hyd. push-off | |
| Gripper slot | |
| 100hp 650/1950 rpm DC drive | |
| Overarm separator | |
| 20" shoes | |
| - Exit Coil Car | Floor mounted |
| Self-contained hydraulics | |
| - Exit Turnstile | 4-arm, 30,000 lbs each |
| Power rotation, C-hook slots | |
| - Scrap Winder | Paxson, DC powered |
| Level wind, hyd scrap dump | |
| - Electrics and Controls | Operators main panel |
| Auxiliary operator stations | |
| AC & DC control cabinets | |
| Eurotherm DC drives | |
| 2 transformers | |
| Sold "as is, where is" installed and under power. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com
Asset Sales and Marketing Software for Used and Surplus Industrial Machinery and Equipment Dealers