| Specification | Description |
|---|---|
| Manufacture | Stamco / 1980 |
| Line Speed | |
| Strip Thickness | .012 - .135" / 0.3 - 3.4mm |
| Strip Width | 60" max / 1524mm |
| Materials Processed | Cold rolled / Galvanized |
| 50,000psi shear strength | |
| Coil Size | ID - 20" & 24" / 508 & 610mm |
| OD - 72" max / 1828mm | |
| Weight - 44,000lbs max/ 20mton | |
| Equipment | |
| - Entry Coil Car | Above floor, "L" type |
| Self-contained hydraulics | |
| - Uncoiler | Hydraulic expanding mandrel |
| Wichita water-cooled brake | |
| Sliding base & edge guide | |
| Powered hold down/feed roll | |
| - Entry Section | Hydraulic peeler |
| Hydraulic pinch rolls | |
| Edge guides | |
| Roller zip type crop shear | |
| X-ray thickness gauge | |
| - Slitter Heads (2) | 2, crane removable heads |
| 6.5" diam arbors | |
| 50 hp AC drive | |
| Double eccentric arbor adjust | |
| Manual outboard housing | |
| 1/4" & 1/2" thick knives | |
| - Scrap Winders | 2 - with auto dump and |
| hydraulic oscillation | |
| - Looping Pit | Entry cascade rolls |
| Pit cross-over table | |
| - Syncrowind Tension Stand | Entry cascade rolls |
| Entry separator bar | |
| Drap wipe with tension pads | |
| Syncrowind rolls | |
| Wichita brakes on each roll | |
| Spare set of rolls | |
| - Rewind | 20" dia hyd. expanding mandrel |
| With plates for 24" OD | |
| Attached overarm separator | |
| Hydraulic push-off | |
| - Rewind Motor | 100hp, 650/1950rpm, 500VDC |
| - Exit Coil Car | Above floor, "V" type |
| Self-contained hydraulics | |
| - Exit Turnstile | 4-arm |
| C-hook access | |
| Hyd. rotation & pushoff | |
| Sold "as is, where is" installed and under power. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com
Asset Sales and Marketing Software for Used and Surplus Industrial Machinery and Equipment Dealers