| Specification | Description |
|---|---|
| Manufacture | Loopco, 1984 |
| Material Processed | Hot & cold rolled steel |
| Shear Strength | 55,000-89,000-119,000psi |
| Strip Thickness | .010 - .188" / 0.25 - 4.7mm |
| Strip Width | 20 - 60" slit / 508-1524mm |
| Coil Size | Entry ID - 20-24" / 508-610mm |
| Exit ID - 20" / 508mm | |
| OD - 72" max / 1828mm | |
| Wt - 44,000lbs max / 20 mtons | |
| Line Speed | Low speed range: 220-660 fpm |
| High speed range: 550-1200 fpm | |
| Hand of Line | Left to right |
| Services Required | 480V, 3 PH, 60 Hz |
| 80 psi air pressure | |
| Slitting Capability-Speed-Cuts/min | |
| - 55,000psi | .062" - 5 cuts at 1200 fpm |
| .121" - 5 cuts at 580 fpm | |
| .187" - 4 cust at 300 fpm | |
| .187" - 5 cuts at 240 fpm | |
| .250" - 3 cust at 225 fpm | |
| - 89,000 psi | .062" - 5 cuts at 1200 fpm |
| .121" - 5 cust at 360 fpm | |
| .187" - 3 cust at 250 fpm | |
| - 119,000 psi | .062" - 4 cuts at 1200 fpm |
| .121" - 5 cust at 333 fpm | |
| .156" - 3 cuts at 270 fpm | |
| Equipment | |
| - Entry Coil Car | Pit mounted, 33" lift |
| 10hp self-contained hydraulics | |
| - Uncoiler | Hyd. expansion - 19.25 - 24.5" |
| 62" face mandrel | |
| 4 pumpkin tooth segments | |
| Driven hold down roll | |
| Peeler | |
| Edge Guide | |
| - Removable Sliiter Head | 7.5" diam x 63" face arbors |
| Jet nuts for locking tooling | |
| 9.5" ID x 12.5" OD knives | |
| 75 hp 1150/2000rpm DC drive | |
| 3.56:1 gear reducer | |
| - Exit Table | |
| - Pit Threading Table | |
| - Tension Stand | Tension pads |
| Overarm separator | |
| - Recoiler | 20" dia hyd expanding mandrel |
| .500" gripper slot | |
| 100 hp 500/2000rpm DC motor | |
| 2-spd gear box-22.89:1, 55.7:1 | |
| - 4-Arm Turnstile | Designed for 60" wide coils at |
| 44,000lbs each | |
| - Scrap Winders and Conveyor | |
| - 2 Hydraulic Power Units | 20hp, 1750rpm AC motor |
| 20 gpm variable volume, | |
| pressure compensated pump | |
| Documentation | Complete electrical and mech- |
| anical drawings | |
| Sold "as is, where is" off foundation, USA |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com