| Specification | Description |
|---|---|
| Manufacturer | Stamco/Hunter/Behlen/Memco |
| Line Speed | |
| Strip Thickness | .050" max / 1.27mm |
| Strip Width | 56" max / 1422mm |
| Coil Size | ID - 20" / 508mm |
| OD - 60" max / 1524mm | |
| Weight - 15,000lbs max / 6.8mt | |
| Equipment | |
| - Entry Turnstile | 4-arm, powered indexing |
| - Entry Coil Car | Floor level, 15,000lb capacity |
| - Uncoiler | 20" diam mandrel |
| Hold down roll, sliding base | |
| - Entry Shear | .048" x 62", hydraulic |
| - Joining Press | 100 ton hydraulic unit |
| 72" wide stitching die | |
| - Edge Trimmer | with scrap winders |
| - Embosser | Memco 190 ton model |
| - Embosser Roll Size | 60" face rolls |
| - Embosser Roll Patterns | Stucco / woodgrain |
| Diamond / pebble | |
| - Entry Leveling Bridle | 4-roll unit |
| 24" diam x 62" face rolls | |
| - Tension Flex-Roll Section | 5 roll cassettes, 2 over 3 |
| - Entry Leveling Bridle | 4-roll unit |
| 24" diam x 62" face rolls | |
| - Thickness Gauge | Non-contact type unit |
| - Exit Shear | .048" x 62", hydraulic |
| - Recoiler | Hyd. expanding mandrel |
| 200 hp DC drive | |
| Hydraulic pushoff | |
| Sliding base | |
| Edge guide | |
| - Exit Coil Car | |
| - Exit Turnstile | 2-arm |
| Sold "as is, where is" installed, not in production. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com