| Specification | Description |
|---|---|
| Manufacturer | Pro Eco/Memco - 1975 |
| Edge trim & leveling new 1990 | |
| Line Speed | 1000 fpm / 305 mpm |
| Strip Thickness | .010 - .070" / 0.25 - 1.78mm |
| Strip Width | 38" entry max / 965mm |
| 36" exit w/ edge trim / 914mm | |
| Coil Size | ID - 16"and20" / 406 & 508mm |
| OD - 60" max / 1524mm | |
| Weight - 9000lbs max / 4.0mton | |
| Leveler Capability | 0.0 - 1.5% elongation based on |
| spec strip of .040" x 36" with | |
| 40,000psi yield strength | |
| Equipment | |
| - Uncoiler | 16" diam mandrel, 20" shoes |
| 40hp DC drive | |
| Floor level coil car | |
| - Behlen Strip Joiner | 38" strip width |
| Single die | |
| - Edge Trimmer | Pro Eco model ET-8-4-36 |
| Butech scrap chopper | |
| - Tension Leveler | |
| - 4-Roll Entry Bridle Section | Rolls = 25.5"diam x 42" face |
| 50, 75, 100, 200 hp drives | |
| All drives are individual | |
| - Flex-Roll Section | Five (5) roll cassettes |
| 2" diam work rolls | |
| 4.5" diam backup rolls | |
| Backup rolls = spiral grooved | |
| Spare set of rolls included | |
| - Transverse Bow Correction Rolls | Exit end of flex-roll section |
| - Exit Tension Bridle (4-Roll Unit) | Rolls = 25.5"diam x 42" face |
| 200, 100, 75, 50 hp drives | |
| All drives are individual | |
| - Embosser | Memco 50/75 ton model |
| 1 matched woodgrain roll set | |
| 37.5" face x 15" diameter | |
| On rails =can pull out of line | |
| - Isolation Bridle #1 | 20hp and 25hp |
| - Slitter | 38" slitter head width |
| 15 hp DC drive | |
| Scrap baller | |
| - Isolation Bridle #2 | 25 hp |
| - Passline Roll Stand | |
| - Recoiler | 16"and 20" mandrel |
| 50 hp DC drive | |
| 850/1700 rpm | |
| Hydraulic push-off | |
| - Controls | Reliance drives |
| Automax PLC in leveler section | |
| Electrical supply is 480/3/60 | |
| Sold "as is, where is" installed and under power. |
PO Box 1164
Roxboro, NC 27573
+1 336 597 2370
+1 336 597 8633
sales@phippsMetals.com